Mitutoyo Surftest Sv400 User Manual !free! Full

Input the known, calibrated value written on the precision specimen. No other manual gain adjustments are required.

Lower the stylus gently onto the workpiece surface until the digital on-screen position indicator rests within the green "Zero" zone. Perform a quick tilt-check preview scan.

Secure irregular parts in a precision vise or clamp to prevent shifting during the trace. Performing the Trace mitutoyo surftest sv400 user manual full

The SV-400/SJ-400 system is highly adaptable when it comes to analyzing and storing data.

Keep away from heavy machinery, stamping presses, or high-traffic walkways. Use an active or passive vibration isolation table if possible. 3. Basic Operation Workflow Input the known, calibrated value written on the

value against the target value engraved on the specimen plate. If the value falls outside the allowed tolerance (

Running a surface roughness test on the SV-400 involves standard metrology steps. Step 1: Powering On the System Switch on the central controller unit. Turn on the host computer and launch the software. Perform a quick tilt-check preview scan

If you just bought a used SV-400 from auction and don't have time to read all 150 pages, follow this:

Supports up to 36 (SJ-400) or 43 (SV-2100) analysis parameters, including 2. Initial Setup and Calibration

Adjust the micrometer heads on the leveling table until the slope inclination angle on the real-time software monitor reads as close to zero degrees ( 0∘0 raised to the composed with power ) as possible. Step 3: Data Acquisition and Saving