Media Converter In Cisco Packet Tracer Link Jun 2026

The PT-SWITCH must be customized to hold both copper and fiber ports.

Go to > Switches and drag a 2960 Switch or a 3650 Multilayer Switch onto the workspace.

This article explores what a media converter is, why you would use it in Packet Tracer, and a step-by-step guide to successfully configuring a scenarios. media converter in cisco packet tracer link

Router> enable Router# configure terminal Router(config)# interface gigabitethernet 0/0 Router(config-if)# ip address 192.168.1.1 255.255.255.0 Router(config-if)# no shutdown Router(config-if)# exit

: Choose a modular router (e.g., Router-PT or 2911 ) or switch (e.g., Switch-PT or 2960 ). The PT-SWITCH must be customized to hold both

If your Packet Tracer version lacks a media converter:

Router> enable Router# configure terminal Router(config)# interface FastEthernet1/0 Router(config-if)# no shutdown Use code with caution. Troubleshooting Connectivity Issues In the physical world, you would place a

This absence can be a problem when you need to build a topology that reflects a real-world scenario where, for example, a legacy switch with only copper ports needs to connect to a high-speed fiber backbone. In the physical world, you would place a media converter between them to handle the signal translation. However, in Packet Tracer, you must find a workaround.

Once connected, the lights on the converter and connected devices should turn green.