This guide serves as an overview of the key sections in the , offering insights into safely operating and maintaining your dental ceramic furnace. 1. Introduction to the Programat P100 Ivoclar Programat P100
Set how long the peak temperature is maintained.
The manual uses standard ISO symbols for danger and important notes.
Every standard ceramic program on the P100 relies on the following sequence of parameters: Standby Temperature (
If the wire surface just begins to melt and ball up at the very end of the cycle, the calibration is perfect.
Turn on the main power switch located at the rear or side of the unit. The display will light up and run a brief self-diagnostic test. Control Panel and Keypad Functions
: Periodically check the sintering chamber for debris or cracks.
Run an empty cycle up to 1050°C once a week to burn off carbon deposits and contaminants inside the insulation.
Regularly remove dust and debris using a soft brush.
Note: These are illustrative examples only. Always follow material manufacturer and Ivoclar recommendations in the official manual.
Place the unit on a flat, level surface away from heaters or other heat sources. Ensure at least 110 mm of space behind the furnace for the swivel movement of the furnace head and adequate air circulation. Connections:
Ivoclar Programat P100 Manual English Instant
This guide serves as an overview of the key sections in the , offering insights into safely operating and maintaining your dental ceramic furnace. 1. Introduction to the Programat P100 Ivoclar Programat P100
Turn on the main power switch located at the rear or side of the unit. The display will light up and run a brief self-diagnostic test. Control Panel and Keypad Functions
Run an empty cycle up to 1050°C once a week to burn off carbon deposits and contaminants inside the insulation.
Regularly remove dust and debris using a soft brush.
Note: These are illustrative examples only. Always follow material manufacturer and Ivoclar recommendations in the official manual.
Place the unit on a flat, level surface away from heaters or other heat sources. Ensure at least 110 mm of space behind the furnace for the swivel movement of the furnace head and adequate air circulation. Connections: