Crawford Cdm9 950 Installation Manual Top [repack] -

: Connect the wicket door interlock into the emergency stop circuit.

: Mount the torque bar to the mechanical unit. Place the rubber shock absorber between the torque bar and the mounting console to dampen vibrations. Height Requirement : The operator should be installed at a height of at least 2.5 meters above the floor for safety. Hurð ehf. ⚙️ Initial Programming & Setup

Remove the front enclosure screws and carefully swing open the protection lid.

For the most detailed, model-specific instructions, always refer to the official documentation: crawford cdm9 950 installation manual top

Press and hold the "Down" button until the door’s bottom rubber edge reaches your 1m mark.

Slide and secure the second flush against the outer assembly to block lateral movement. Step 3: Torque Bar Anchoring

The information provided in this feature is for general purposes only and should not be considered as a substitute for the manufacturer's instructions and guidelines. Always consult the Crawford CDM9 950 installation manual and manufacturer's website for the most up-to-date information and instructions. : Connect the wicket door interlock into the

installation manual, top setup techniques, wiring profiles, and troubleshooting steps. Technical Specifications & Variants

Slide the complete CDM9 operator onto the shaft. Secure it by mounting the second stop ring to lock the horizontal alignment.

The manoeuvring card contains LEDs that indicate the status of the stop circuit and the upper limit switch. Height Requirement : The operator should be installed

While the full manual provides exact torque specs and fastener schedules, here are the three phases that define a successful CDM9 950 install:

Before beginning installation, verify that your door requirements match the specific capacity of your CDM9 drive unit: Specification 340 x 230 x 140 mm Height x Width x Depth Weight Unit weight without accessories Supply Voltage 230V AC Single Phase 50/60Hz, 2A draw Protection Class IP55 rating Standard enclosure (CEE plug is IP44) Standard Capacity Up to 400 kg Standard CDM9 unit maximum load Heavy Duty Capacity 400 kg to 800 kg CDM9HD unit variation range High Speed Capacity Up to 250 kg CDM9 2H dual-speed version Mechanical Installation and Drive Unit Assembly